Marshall Amplifier : 30W MG Carbon Fibre (MG30CFX)

Product Description

With a totally new internal design and approach, the new MG Series delivers essential digital features, but with vast superior and programmable analogue tone at its heart. Specially voiced digital effects, intuitive footswitching technology and four adjustable and storable channels are just a few of the features to be found in this mighty amplifier range

This rugged 1x10" combo contains all the incredible features of the MG15FX but doubles the pleasure, delivering a superb 30 Watts of pure analogue Marshall tone and power. A truly versatile unit and a worthy addition to any guitarists arsenal of amplifier.

1. Input Jack Socket
Jack input for your guitar. Use a good quality guitar
cable (i.e. one that’s screened/shielded) to help prevent
noise, interference and unwanted feedback.

2. Gain Control
Controls the amount of signal entering the pre-amp and
the amount of distortion created in the selected channel.

3. Clean : Crunch Switch
Selects between Clean (green) and Crunch (red) channels.

4. Bass Control
Turning up the Bass control will add warmth and lowend depth to your sound.

5. OD Switch
Selects between OD1 (green) and OD2 (red) channels.

6. Middle Control
Adjusting the middle frequencies will vary the amount of
body in your sound.

7. Treble Control
Increasing the Treble will make your sounds brighter
and more cutting, turning it down will decrease your
tone’s edge and make it sound softer as a result.

8. Reverb Control
This control lets you add a lush reverb to the selected
channel, from a subtle hint to cavernous and all points
in-between.

9. Volume Control
Controls the volume of the selected channel.

10. Tap (Manual) Switch
Matches the delay FX time to the time between two
pushes. The LED flashes at the selected delay time.
Holding down the Tap switch for longer than 2 seconds
switches the amp between manual and preset mode (pg 2).
When using the optional footcontroller, holding both the
Tap switch and the Store switch will activate the tuner.

11. FX Control
Selects and adjusts one of four effects - Chorus,
Phaser, Flanger & Delay.

12. Store Switch
Stores the current amp settings into the current channel
or into the optional footcontroller. When in manual mode
the Store button lights red.

13. Master Control
Controls the master volume of the amplifier.

14. MP3 Line In Socket
Jam to your favourite MP3, CD or tape track by
connecting the line out or headphone output of your
player here. Adjust the volume of your player to match
that of your guitar and you’ve got the perfect ‘playalong’ practice system.

15. Footcontroller Socket
¼" Jack socket for the connection of the optional
footcontroller (PEDL-90008) - see page 8.

16. Headphones Socket
For use when silent practice is the order of the day.
Connection of headphones will automatically mute the
internal speaker.

17. Power Switch
The power switch turns your amplifier on and off. A
channel switch will light up when your amplifier is turned
on and none will be lit when the amplifier is switched off.

Note: The specific mains input voltage rating that your amplifier has been built for is shown on the back panel.

Before connecting to the mains electricity supply,
always ensure that your amplifier is compatible with
your electricity supply. If you have any doubt, please get
advice from a qualified technician. Your Marshall dealer
will help you in this respect.

Please ensure the amplifier is switched off and unplugged from the mains electricity supply before being moved